T5, T14D, T40 Blast Chiller/Shock FreezersService, Installation and Care ManualPlease read this manual completely before attempting to install or oper
10 5.Rimuovere la porta dell’abbattitore Remove the chiller door 6.Rimuovere la cerniera superiore destra ruotarla di 180° edinstallarla s
115. Remove the chiller door.6. Remove the right top hinge. Rotate it 180º and install it on the left top side of the chiller.Cerniera inferiore destr
1210.Fissare la porta effettuando la regolazione delle cerniere in modo da garantire una correttachiusura ed aderenza della guarnizione porta.Successi
133.1 Shut-down procedures Intheeventofemergency,shutdowntheappliance by switching o power at the mainpanel,bymeansofabreakerorpower
144. DESCRIPTION OF THE VERTICAL CONTROL PANEL+38°0°+38°HARD°CHACCP PROGRAM65151121035a45b1478911213
154.1PUSH-BUTTONS:1.ON /OFF (STAND BY)2.SOFT BLAST CHILLING CYCLE (+38°F / +3°C)3.HARD BLAST CHILLING CYCLE (+38°F / +3°C)4.BLAST FREEZING CYCLE (0°F
5.1 STARTING UP THE APPLIANCE (only for T14D / T40)PRE HEATING FUNCTION OF COMPRESSOR SUPWhenpowerisinitiallysuppliedtothecabinet,a2-hourpre
17IMPORTANT: work cycles and modes can only be selectedwhentheapplianceisON(LEDonpush-button 6 o)IMPORTANT: The appliance will automaticall
18•Attheendofthechillingcycle,theapplianceautomaticallyswitchestothesetstoragetemperatureforanindenite interval (like a standard s
195.4 HARD BLAST CHILLING BY TEMPERATURE•Presspush-button 3(relativeLEDlightsup),thenpresspush-button5 to select the temperature mode (LE
2
20The time setting (in minutes) can be modied by means of push-buttons 74.1PUSH-BUTTONS:1.ON /OFF (STAND BY)2.SOFT BLAST CHILLING CYCLE (+38°F / +3°C
215.7 TIMED BLAST FREEZING•Presspush-button44.1PUSH-BUTTONS:1.ON /OFF (STAND BY)2.SOFT BLAST CHILLING CYCLE (+38°F / +3°C)3.HARD BLAST CHILLING CYC
226.1 DATE AND TIME SETTINGS : PUSH-BUTTON (5)SetthemachinetoON4.1PUSH-BUTTONS:1.ON /OFF (STAND BY)2.SOFT BLAST CHILLING CYCLE (+38°F / +3°C)3.H
236.5 DISPLAYING THE THREE LATEST HACCP ALARMS (PUSH-BUTTON 10)Set the machine to ON 4.1PUSH-BUTTONS:1.ON /OFF (STAND BY)2.SOFT BLAST CHILLING CYCLE
7. ALARM MANAGEMENT7.1 Storage of data/errorsThe appliance electronic controller is equipped with a system of acoustic and visual signals to indicate
25 Input SW2 (ALL 05) (door microswitch alarm)Cause: Input active for more than 5 minutes with appliance in start status. Door open (close door) M
26 Excessive temperature alarm (ALL 11)Cause: (only during storage) cell probe constantly detects a temperature greater than the sum of positive or
27INFORMATION ON ALARMS:Duringalarms,thebeeperisactivatedandthedisplayshowsthemessage“ALLxx”.Thealarmmessageisalternatedonthedispl
8. MAINTENANCE AND CLEANINGThe information and instructions given in this section address all persons operating the appliance:theuser,themaintenanc
29Delfield™®T5: Blast Chiller/Shock Freezer31.89”(81.2)31.50”(80.0)27.56”(70.0)29.92”(75.9)57.48”(145.9)37.89”(96.2)27.56”(70.0)A13.58”(34.5)13.58”(34
3WARNING Read This Manual Thoroughly Before Operating, Installing, Or Performing Maintenance On The Equipment.WARNING Failure To Follow Instructions
30Delfield™®T14D: Blast Chiller/Shock Freezer67.95”(172.6)43.31”(110.0)29.92”(75.9)73.23”(186.0)73.95”(187.8)43.3131.50”(80.0)28.7825.98”(65.9)6.00”(1
31Delfield™®T40: Blast Chiller/Shock Freezerby Delfield® 38 38 0 ™ Sample PrintoutREFRIGERANT & ELECTRICAL LINESDRAINDRAIN30”5.5”REFRIGERANT &
32Delfield™®T40Deleld Model#: T40CURefrigerant 404ACompressor and wiringCompressor and Capacity6 HP Compressor24,150BTUH@-32˚F,90amb,102.2Cond
33Delfield™®T40CUW: Remote Water Cooled Condensing UnitT40DeleldModel#:T40CUWRefrigerant 404ACompressor and wiringCompressor and Capacity6 HP Compr
3410. T5/T14D REFRIGERATION SYSTEM SCHEMATIC
3511. WIRING DIAGRAMS
36
37
38T40RSWallPanelSupplied Equipment List.T40 BaseT40LSWallPanelT40 Back PanelT40 Control BoxT40 Front Panel with DoorT40 Top PanelT40 Air Deecti
391.Positioncabinetflooronaflat,levelsurfacewiththeslottedend facing up.•Ensuretheentrywayisfacingforward (gray plastic transition
4CONTENTS1. GENERAL DOCUMENTATION1.1 General information 61.2 Installation 61.3 Transport and handling 61.4 Unpacking 61.5 General s
404. Attach the right side panel to the mounting floor in the same manner as the other two panels. Lock the side locking cams on the inside bottom and
418. Thread electrical from the inside of the unit through the supplied hole in the top. Do not cut another hole to thread electrical. 9. Thread elect
4213. NOTES
4313. NOTES
44Mt. Pleasant, MI Covington, TN980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (989) 773-7981 or (800) 733-8829 • Fax (989) 773-3210 • www.del
5Visit http://www.delfield.com/minisite/service/warranty_info to:• Register your product for warranty.• Verify warranty information.• View and down
61.1. General information•Thismanualisanintegralpartoftheproduct,providing all the information required to ensure correctinstallation,oper
72. INSTALLATION2.1 Data plate information•Checkthatthedataspeciedontheplatecorrespond to the characteristics of the power supply(V,kW,Hz
82.6 Condensate drainage connection For T40 models t a condensate water drainage hose with a minimum diameter of 1” . Provide a waste pipe with a t
9T5/T14D DELFIELD PROCEDURA PER LA ROTAZIONE DELLA PORTA DOOR ROTATION PROCEDURE1.Rimuovere l
Comments to this Manuals